fbpx

AEROTRACH PLUS* Anti-Static Valved Holding Chamber

RM120.00

The AEROTRACH PLUS* Anti-Static Valved Holding Chamber (VHC) is specifically designed for the delivery of metered dose inhaler (MDI) medications for tracheostomy patients.

The AEROTRACH PLUS* Anti-Static Valved Holding Chamber (VHC) is specifically designed for the delivery of metered dose inhaler (MDI) medications for tracheostomy patients.

The AEROTRACH PLUS* Anti-Static Valved Holding Chamber (VHC) is quick and easy to comfortably connect to standard 15mm tracheostomy tubes.

  • Use of a chamber improves delivery of medication1
  • Ready to use directly out of the package – time saving with no pretreatment needed
  • Anti-static improves the reliability of medication delivery2

1. Federico Lavorini, et al. Targeting Drugs To The Airways: The Role Of Spacer Devices. Expert Opinion on Drug Delivery 2009;6(1):91-102.

2. Jason Suggett, et al. Use Of Valved Holding Chambers Without Pre-conditioning And The Influence Of Anti-static Materials. Journal of Aerosol Medicine and Pulmonary Drug Delivery 2014;28.

How to Use

Step 1

Remove the cap from the inhaler. Shake the inhaler immediately before use as per the instructions supplied with it.

ifu2_aerotrach.png

Step 2

Insert the inhaler into the backpiece of the chamber.

Step 3

Connect the trach adapter of the chamber to the connection on the tracheostomy tube. Note: This device is designed as a slip fit onto the tracheostomy tube connection. It must be held in place during administration of medication.

Step 4

Press the inhaler once at the beginning of a slow inhalation. Hold in place for 5-6 breaths. Administer one puff at a time. Follow the instructions supplied with the inhaler on how long to wait before repeating.

Cleaning

This anti-static chamber can be used right out-of-package and then cleaned daily.

Step 1

Remove back piece only. (Do not remove the trach adapter assembly.)

Step 2

Soak the parts for 15 minutes in a mild solution of liquid dish detergent and lukewarm clean water. Agitate gently. Rinse parts in clean water.

Step 3

Shake out excess water and allow to air dry in a vertical position. Ensure parts are dry before reassembly.

Step 4

Replace backpiece when unit is completely dry. Store in a clean, dry place when not in use.

Disinfection

Prior to disinfection, follow cleaning instructions. Do not dry or reassemble the device.

Step 1

Soak the two parts in a 1:10 bleach to water solution for 30 minutes. Rinse parts in clean water. Note: You may substitute an enzyme solvent or VitalOxide† for the bleach solution. Follow the disinfectant instructions for use.

Step 2

Shake out all excess water and allow to air dry in an upright position. Ensure the parts are dry before reassembly.

Step 3

Replace backpiece when unit is completely dry.

Related products

Shopping Cart
Scroll to Top